Merrick site check: homes, soil, flood zones and water
| Merrick | Here | Nassau County |
|---|---|---|
| Single-family detached homes | about 96% | about 76% |
| Owner-occupied | about 97% | about 82% |
| Median home value | about $772,000 | about $685,000 |
| Built before 1960 | about 63% | about 66% |
| Homes per square mile | 1,980 | – |
| Most common soil | Urban land-Sudbury complex: built-over ground with Sudbury soil in the yards (26% of land) | |
| Land on 8%+ slopes | 0% | |
| Soil with a seasonal water table within ~3 ft | 35% | |
| Land in a FEMA flood zone | 31% (AE 30%, A 1%) | |
| Public water supplier | Liberty Utilities (Merrick system) (99%) | |
| Pool permits from | Town of Hempstead Department of Buildings | |
Merrick by the numbers
Merrick is a South Shore hamlet of owner-occupied single-family homes: about 96% detached and about 97% owner-occupied, with a median build year of 1956 (Census ACS 2020–2024). At about 1,980 homes per square mile, lots are mid-sized for Nassau. The median home value, around $772,000, sits above the Nassau County median.
What the Town of Hempstead’s code means for a Merrick yard
Merrick’s permits come from the Town of Hempstead, whose 4-foot side and rear setback is one of the smallest on Long Island, so the binding limit is usually the 40% rear-yard cap. Two details matter more in Merrick than elsewhere: corner lots (10 feet from any line along a street, common on Merrick’s grid) and cabanas, which the town allows only at 7¼ feet tall or less, 700 cubic feet or less, 10 feet from all lines and opening inside the pool fence. The fence and gate spec is on the Town of Hempstead pool permit page.
The 40% math
Measure your rear yard (behind the house, side line to side line) and take 40%. That’s the most pool the town allows, before patios and the fence eat into the usable space. On a typical Merrick lot, that comfortably fits a standard vinyl or gunite rectangle; on smaller lots, it’s the number to give your builder up front.
Published Long Island prices: vinyl $35,000 – $100,000, gunite $60,000 – $250,000.
Merrick’s flood zones and groundwater
Merrick has more land in a FEMA flood zone than any other town on this site outside the East End: about 31% in our sample, almost all AE, with base flood elevations of 7 to 11 feet in the mapped areas near the bay and canals. The USDA soil survey puts about 35% of the hamlet on soil with a seasonal water table within about 3 feet, mostly Urban land–Sudbury complex (26% of land) and sand fill over a wet substratum (26%).
So a south-of-Merrick-Road pool is a different job from one up near Camp Avenue:
- Ask whether the quote includes dewatering if the dig hits water, and a hydrostatic relief valve.
- In an AE zone, the town’s floodplain rules apply on top of the pool code. Keep the heater, pump and electrical panel above the flood elevation the permit sets.
- Since Hurricane Sandy, many bay-side houses here have been raised. If yours was, the pool and patio grades have to work with the new first-floor height and the stairs.
Check your lot on FEMA’s map for Merrick. Water for the fill comes from Liberty Utilities’ Merrick system, which covers about 99% of the hamlet on EPA’s service-area map.
| Soil | Share of land | What it is | Seasonal water table |
|---|---|---|---|
| Urban land-Sudbury complex | 26% | built-over ground with Sudbury soil in the yards | about 2 ft |
| Urban land-Riverhead complex (0–3% slopes) | 26% | built-over ground with Riverhead soil in the yards | deeper or not rated |
| Urban land-Udipsamments, wet substratum complex | 18% | built-over ground with Udipsamments soil in the yards | deeper or not rated |
| Udipsamments, wet substratum | 8% | reworked sand with groundwater below | deeper or not rated |
Guides for Merrick homeowners
- How big a pool fits your Long Island lot? Setbacks, worked out
- Pool alarm requirements in New York: what Long Island pools need
Merrick pool questions
Do I need a permit for a pool in Merrick?
Yes, from the Town of Hempstead Department of Buildings. The plans must meet the department's requirements, or a NY-licensed engineer must certify (with Town Engineer approval) that the pool's drainage won't affect the water supply, sanitary systems or roads.
How big can a pool be on a Merrick lot?
The Town of Hempstead caps a pool at 40% of the rear yard, not counting garages and other accessory structures. A rear yard of 2,500 square feet allows up to 1,000 square feet of pool, which is roomy for a 16×32.
Does Merrick require a pool alarm?
Yes. The Town of Hempstead requires an approved, working pool alarm on every pool, and applied it to existing pools starting May 15, 2009.
Is a Merrick pool in a flood zone?
Possibly: about 31% of Merrick's land in our sample of FEMA's current maps is in a special flood hazard area (mostly AE, base flood elevations 7 to 11 feet). If your lot is one of them, the Town of Hempstead's flood rules apply to the pool and its equipment.
Sources
- U.S. Census Bureau, ACS 2020–2024 5-year: Merrick and Nassau County housing tables
- USDA NRCS, Soil Survey Geographic Database (SSURGO) via Soil Data Access
- USDA NRCS Web Soil Survey (look up your own lot)
- FEMA Flood Map Service Center, National Flood Hazard Layer
- U.S. EPA, Community Water System Service Area Boundaries
- Town of Hempstead Building Zone Ordinance, Art. XXV Swimming Pools
- Town of Hempstead (official site)