Nassau County · Incorporated village

Pool installation in Garden City, NY: the lot, setback and fence rules

Garden City site check: homes, soil, flood zones and water

Garden City vs. Nassau County. Housing: Census ACS 2020–2024 5-year. Land shares: our grid sample of USDA, FEMA and EPA maps over the town boundary, November 2026.
Garden CityHereNassau County
Single-family detached homesabout 83%about 76%
Owner-occupiedabout 94%about 82%
Median home valueabout $1,076,000about $685,000
Built before 1960about 83%about 66%
Homes per square mile1,511–
Most common soilUrban land-Hempstead complex: built-over ground with Hempstead soil in the yards (62% of land)
Land on 8%+ slopes0%
Soil with a seasonal water table within ~3 ft0% (14% is pavement or fill the survey doesn't rate)
Land in a FEMA flood zonenone found in our sample
Public water supplierVillage of Garden City water system (93%)
Pool permits fromIncorporated Village of Garden City Building Department, (516) 465-4040

The 12,000-square-foot test comes first

Garden City is one of the few places on Long Island where the code sets a minimum lot size for a pool: no pool on a plot smaller than 12,000 square feet. The village is built out with older homes (the median was built in 1951, and about 83% predate 1960, Census ACS 2020–2024), and at about 1,511 homes per square mile of land, plenty of lots fall under that line. Check your survey before you get any further.

Setbacks by zoning district

If the lot qualifies, the district decides how much room is left:

District From side lines From rear line From habitable buildings
R-6, R-8, R-12 20 ft 20 ft 10 ft
R-20 25 ft 25 ft 15 ft
R-40 30 ft 35 ft 15 ft

The pool walls, the platform around it and the foundation for the filter equipment all count when these distances are measured, and the pool must be in the rear yard.

The fence is a landscaping project

Garden City requires a 6-foot fence fully enclosing the pool, screened with evergreen shrubs so it can’t be seen from the neighbors or the street. Its location and design go on a landscaping plan approved by the Zoning Board of Appeals, and the screening has to be maintained as long as the pool exists. Budget for the plantings and the ZBA step in your timeline, not just the fence.

Designed by a professional, drained underground

Every Garden City pool has to be designed by a licensed engineer or architect and approved by the Superintendent of the Building Department. The design needs permanent drainage that can empty the whole pool underground within 24 hours, separate from the house drains, plus an approved cover for when the pool is empty or not in use and a pool alarm.

With a median home value around $1.08 million, most Garden City projects lean toward gunite ($60,000 – $250,000 on published Long Island prices), and the engineering, fence and screening rules add to any pool type’s cost.

Digging in old Hempstead Plains soil

Garden City sits on the old Hempstead Plains, and the USDA soil survey still shows it: about 62% of the village’s land is mapped as Urban land–Hempstead complex and another 16% as plain Hempstead silt loam, a deep, well-drained silt loam over glacial sand and gravel. None of the village’s land falls on slopes of 8% or more in our sample, and the survey doesn’t list a seasonal water table within about 3 feet anywhere we checked. No part of the village came up inside a FEMA flood zone.

For a pool that’s about as easy as Long Island digging gets: flat yards, firm walls and dry holes. The work that takes time in Garden City is above ground. The village’s permanent-drainage rule means the plans need a way to empty the whole pool on your own lot, usually a dry well sized by the engineer (how pool dry wells work). The evergreen screening around the 6-foot fence goes on the ZBA landscaping plan, so plant costs belong in the budget from day one (pool fence options).

Water comes from the Village of Garden City’s own system (93% of the village’s land falls inside its EPA-mapped service area). A 16×32 pool averaging 5 feet deep holds about 19,000 gallons, and that first fill shows up on the village water bill unless you have it trucked in.

What Garden City pools tend to cost

With a median home value around $1.08 million (Census ACS 2020–2024) and lots that must be at least 12,000 square feet to qualify, most Garden City projects are custom gunite rather than kit vinyl. Published Long Island prices put gunite at $60,000 – $250,000, and a pool with spa and patio at $90,000 – $150,000. Add the engineer’s drainage design, the ZBA-approved plantings and the 6-foot fence. Start with gunite pools on Long Island and the full price survey.

Soils mapped in Garden City (USDA soil survey). Look up your own lot.
SoilShare of landWhat it isSeasonal water table
Urban land-Hempstead complex62%built-over ground with Hempstead soil in the yardsdeeper or not rated
Hempstead silt loam16%deep silt loam of the old Hempstead Plainsdeeper or not rated
Urban land13%pavement and buildings; not rated by the surveydeeper or not rated
Urban land-Riverhead complex (3–8% slopes)3%built-over ground with Riverhead soil in the yardsdeeper or not rated

Village of Garden City's own pool code

What counts as a pool here: Any outdoor pool deeper than 2 feet.

Permit and plans

  • Every pool must be designed by a licensed engineer or architect and approved by the Superintendent of the Building Department.
  • No pool may be built on a plot smaller than 12,000 square feet.

Where the pool can go

  • Rear yard only.
  • From side lot lines: 20 feet in R-6, R-8 and R-12 districts, 25 feet in R-20 and 30 feet in R-40. From the rear line: 20, 25 and 35 feet respectively.
  • At least 10 feet from any habitable structure (15 feet in R-20 and R-40). The pool walls, platform and equipment foundation count when measuring.

Fence and barrier

  • A 6-foot fence fully enclosing the pool, screened with evergreen shrubs so it can't be seen from neighbors or the street. Its location and design go on a landscaping plan approved by the Zoning Board of Appeals and must be maintained as long as the pool exists.
  • Gates self-close and self-latch, and stay locked when the pool isn't in use.

Pool water and drainage

  • The pool needs permanent drainage that can empty it entirely within 24 hours through diffusion wells or similar underground disposal, separate from the house drains and sewer. Never into a street, storm drain, pond, watercourse or a neighbor's land.

Alarms, covers, equipment and neighbors

  • An approved cover whenever the pool is empty or not in use, and pool alarms meeting the state code.

Summarized from Village Code Ch. 200 § 200-45 (Swimming pools), amended March 20, 2025. Checked November 2026. Codes change, so confirm with the Village of Garden City building department before work starts.

Guides for Garden City homeowners

Garden City pool questions

Can I put a pool on a small lot in Garden City?

Not under 12,000 square feet. The village code says no pool may be built on a plot smaller than that, regardless of the setbacks.

How far from the property line does a pool have to be in Garden City?

From the side lines: 20 feet in R-6, R-8 and R-12 districts, 25 feet in R-20 and 30 feet in R-40. From the rear line: 20, 25 and 35 feet. And 10 feet (15 in R-20 and R-40) from any habitable building on the lot.

Where does the pool water go in Garden City?

Into permanent underground drainage, such as diffusion wells, that can empty the entire pool within 24 hours, kept separate from the house drains and sewer. Pool water can't go to the street, a storm drain, a pond or a neighbor's land.

Is Garden City in a flood zone for pool purposes?

Not in our sample. None of the village's land fell inside a FEMA special flood hazard area on the current National Flood Hazard Layer. Check your own address on FEMA's Flood Map Service Center before you file.

Where does the water to fill a Garden City pool come from?

From the Village of Garden City's water system, which covers about 93% of the village's land on EPA's service-area map. A 16×32 pool needs roughly 19,000 gallons for the first fill; some owners have it trucked in instead.

Sources

  1. U.S. Census Bureau, ACS 2020–2024 5-year: Garden City and Nassau County housing tables
  2. USDA NRCS, Soil Survey Geographic Database (SSURGO) via Soil Data Access
  3. USDA NRCS Web Soil Survey (look up your own lot)
  4. FEMA Flood Map Service Center, National Flood Hazard Layer
  5. U.S. EPA, Community Water System Service Area Boundaries
  6. Village of Garden City Code § 200-45, Swimming pools

Get a written pool price in Garden City

Tell us your town and the project. A licensed, independent Long Island pool company calls you back and gives you the price before any work starts. Free to ask, no obligation.

Get a free quote Call (631) 856-2404
  • No fee to you
  • Price in writing first
Call (631) 856-2404 Get a quote