Nassau County · Town of North Hempstead

Pool installation in Port Washington, NY: rules, fences and costs

Port Washington site check: homes, soil, flood zones and water

Port Washington (Census-designated place) vs. Nassau County. Housing: Census ACS 2020–2024 5-year. Land shares: our grid sample of USDA, FEMA and EPA maps over the town boundary, November 2026.
Port WashingtonHereNassau County
Single-family detached homesabout 72%about 76%
Owner-occupiedabout 77%about 82%
Median home valueabout $1,003,000about $685,000
Built before 1960about 70%about 66%
Homes per square mile1,544–
Most common soilPits, sand and gravel: old sand and gravel pits (24% of land)
Land on 8%+ slopes13%
Soil with a seasonal water table within ~3 ft23% (35% is pavement or fill the survey doesn't rate)
Land in a FEMA flood zone5% (VE 3%, AE 3%)
Public water supplierPort Washington Water District (92%), Roslyn Water District (5%)
Pool permits fromTown of North Hempstead Department of Building, Safety, Inspection & Enforcement, (516) 869-7660

Port Washington’s homes

Port Washington’s housing is older and pricier than Nassau as a whole: a median build year of 1953, about 70% of homes from before 1960, and a median value around $1 million (Census ACS 2020–2024). About 72% of homes are single-family detached, at roughly 1,544 homes per square mile.

Town or village?

The Port Washington peninsula is a patchwork. The unincorporated hamlet uses the Town of North Hempstead; incorporated villages such as Sands Point, Port Washington North, Baxter Estates and Manorhaven run their own building departments. Check before you design anything.

What the town code means on the peninsula

In the unincorporated hamlet, the Town of North Hempstead’s rules apply: Nassau County Health Department approval first, an engineer’s drainage certification, rear yard only, 10 feet from the side and rear lines for the pool and its equipment, a 40% rear-yard cap shared with sheds and garages, and a 6-foot fence on its own permit. On the peninsula, the drainage certificate is the part that takes real design work, because of the slopes and the soils below. The full code is on the Town of North Hempstead pool permit page.

Sand pits, fill and the harbor

Port Washington’s ground has a history you can see in the soil survey. The peninsula was mined for sand and gravel for more than a century, and about 24% of its land is still mapped as old sand and gravel pits. Another 9% is reworked sand, and about a third of the land is pavement, pits or fill that the USDA survey doesn’t rate at all. Where the natural soils remain, they’re mostly Montauk till and Riverhead sandy loam, and about 13% of the land is on slopes of 8% or more.

If your house was built on or near the old pit lands, ask for a soil boring or test pit before signing. Loose fill settles under a pool and its patio, and an engineer may call for over-excavation and compacted stone. On the Montauk soils, plan for perched water in the hole.

About 5% of the hamlet’s land is in a FEMA flood zone, split between AE and coastal VE zones along the harbor, where base flood elevations reach 23 feet. A pool in a VE zone is a job for an engineer from the first sketch. Check FEMA’s map for Port Washington. Water comes from the Port Washington Water District (about 92% of land on EPA’s map), with a sliver of the Roslyn Water District.

Choosing a pool for a peninsula lot

On sloped or filled lots, custom gunite adapts to odd shapes and retaining walls better than a fixed fiberglass shell, though both work on firm ground. If the lot backs onto the harbor, read the Town of North Hempstead rules on drainage certification before you design.

Soils mapped in Port Washington (USDA soil survey). Look up your own lot · FEMA flood map for Port Washington.
SoilShare of landWhat it isSeasonal water table
Pits, sand and gravel24%old sand and gravel pitsdeeper or not rated
Urban land-Montauk complex (3–8% slopes)14%built-over ground with Montauk soil in the yardsabout 3 ft
Urban land-Riverhead complex (3–8% slopes)11%built-over ground with Riverhead soil in the yardsdeeper or not rated
Udipsamments, nearly level9%reworked or filled sanddeeper or not rated

Port Washington pool questions

What fence materials does North Hempstead allow around a Port Washington pool?

A 6-foot solid wood, solid vinyl, or vertical wrought iron fence with openings no more than 4 inches, or chain link that meets the state code. The finished side faces the neighbors and the street, and the bottom can't be more than 2 inches off the ground.

Can I fill my Port Washington pool from my own well?

The Town of North Hempstead says a pool filled from a private well can't be cross-connected to the public water system, and a pool filled from the public system needs an approved backflow device with the inlet above the overflow.

Can pool lights or speakers bother neighbors in Port Washington?

The town code bars loudspeakers that can be heard past the property line and pool lighting that shines past it.

Do I need a soil test for a pool in Port Washington?

It's worth asking for one. About 24% of the peninsula's land is mapped as old sand and gravel pits, and more is fill. Loose fill can settle under a pool and patio, so an engineer may call for over-excavation and compacted stone.

Sources

  1. U.S. Census Bureau, ACS 2020–2024 5-year: Port Washington and Nassau County housing tables
  2. USDA NRCS, Soil Survey Geographic Database (SSURGO) via Soil Data Access
  3. USDA NRCS Web Soil Survey (look up your own lot)
  4. FEMA Flood Map Service Center, National Flood Hazard Layer
  5. U.S. EPA, Community Water System Service Area Boundaries
  6. Town of North Hempstead Code § 70-102, Outdoor pools
  7. Town of North Hempstead Department of Building, Safety, Inspection & Enforcement

Get a written pool price in Port Washington

Tell us your town and the project. A licensed, independent Long Island pool company calls you back and gives you the price before any work starts. Free to ask, no obligation.

Get a free quote Call (631) 856-2404
  • No fee to you
  • Price in writing first
Call (631) 856-2404 Get a quote