Suffolk County · Town of Riverhead

Pool installation in Riverhead, NY: town rules and costs

Riverhead site check: homes, soil, flood zones and water

Riverhead (Census-designated place) vs. Suffolk County. Housing: Census ACS 2020–2024 5-year. Land shares: our grid sample of USDA, FEMA and EPA maps over the town boundary, November 2026.
RiverheadHereSuffolk County
Single-family detached homesabout 58%about 80%
Owner-occupiedabout 61%about 82%
Median home valueabout $457,000about $578,000
Built before 1960about 32%about 31%
Homes per square mile383–
Most common soilHaven loam (0–2% slopes): deep, well-drained loam over sand and gravel (21% of land)
Land on 8%+ slopes4%
Soil with a seasonal water table within ~3 ft7%
Land in a FEMA flood zone2% (AE 2%, VE 1%)
Public water supplierRiverhead Water District (100%)
Pool permits fromTown of Riverhead Building Department, (631) 727-3200, ext. 213

Riverhead’s homes and land

The hamlet of Riverhead has the newest housing of any town on this site, with a median build year of 1984, and the most land: roughly 383 homes per square mile, about 73,000 square feet per home spread evenly, because so much of the hamlet is farmland and open space (Census ACS 2020–2024 and the 2024 Gazetteer). About 58% of homes are single-family detached, and the median value is around $457,000.

Riverhead’s fence spec in practice

Riverhead writes its pool fence like an engineering spec: picket and chain-link openings of 2⅜ inches or less, posts and rails that resist a 150-pound sideways push, and no more than 2 inches at the ground. In practice, many off-the-shelf “pool fence” panels sold up-island don’t meet the opening size, so have the installer confirm the product against the code before ordering. If the house forms part of the enclosure, the windows, swinging doors and sliders facing the pool each have their own latch rules. The exact wording is on the Town of Riverhead pool permit page.

Wires, wetlands and abandoned pools

The town keeps any wiring other than the pool’s own 15 feet from the water, which on farm-country lots usually means checking where the service line to a barn or outbuilding runs. Near wetlands, the code adds a pump-out and a dry well for pool discharge. And if an old pool is being abandoned, the Zoning Officer hears about it twice: before it’s filled and after the grade is restored. Price check: vinyl $35,000 – $100,000, removal $5,000 – $25,000.

Farm-country soil and its own water district

Riverhead’s ground is the good farm soil of the North Fork’s western end. The USDA maps about 21% of the hamlet as Haven loam and 30% as Riverhead sandy loam, both deep and well drained, and only about 4% of the land is on slopes of 8% or more. About 27% is excessively drained sand. A seasonal water table within about 3 feet shows up on only about 7% of the land, and about 2% is in a FEMA flood zone along the Peconic River and Flanders Bay.

For most lots that means a straightforward dig with a lot of room around it; Riverhead has the most land per home of any hamlet on this site. Near the river and wetlands, the town requires a pump-out and a dry well at least 4 by 4 feet, and the DEC may have jurisdiction too.

Riverhead is also one of the few places on this site with its own water supplier: the Riverhead Water District covers the whole hamlet on EPA’s service-area map, so your first fill shows up on its bill, not the Suffolk County Water Authority’s.

Soils mapped in Riverhead (USDA soil survey). Look up your own lot · FEMA flood map for Riverhead.
SoilShare of landWhat it isSeasonal water table
Haven loam (0–2% slopes)21%deep, well-drained loam over sand and graveldeeper or not rated
Riverhead sandy loam (0–3% slopes)15%deep, well-drained sandy loam over sand and graveldeeper or not rated
Riverhead sandy loam (3–8% slopes)15%deep, well-drained sandy loam over sand and graveldeeper or not rated
Cut and fill land, gently sloping9%regraded or filled ground; ask for a soil checkdeeper or not rated

Guides for Riverhead homeowners

Riverhead pool questions

What are Riverhead's pool fence rules?

At least 4 feet high, no more than 2 inches off the ground, finished side away from the pool, picket and chain-link openings no wider than 2⅜ inches, no footholds, posts and rails that resist a 150-pound sideways load, and fabric that resists 50 pounds on any 12-inch square. Pools under 24 inches deep are exempt.

Can power lines run near a pool in Riverhead?

No current-carrying conductors may cross a pool, overhead or underground, or be installed within 15 feet of it, except the wiring for the pool's own equipment and lighting. Nearby metal fences and railings must be grounded.

What does Riverhead require near wetlands?

Within the Conservation Advisory Council's jurisdiction, pools need a pump-out and a dry well at least 4 feet across and 4 feet deep for pool discharge, placed per the town's wetland setbacks. Draining a pool into wetlands or any water body is prohibited.

Who supplies the water to fill a pool in Riverhead?

The Riverhead Water District, which covers the whole hamlet on EPA's service-area map. A 16×32 pool needs roughly 19,000 gallons for the first fill.

Sources

  1. U.S. Census Bureau, ACS 2020–2024 5-year: Riverhead and Suffolk County housing tables
  2. USDA NRCS, Soil Survey Geographic Database (SSURGO) via Soil Data Access
  3. USDA NRCS Web Soil Survey (look up your own lot)
  4. FEMA Flood Map Service Center, National Flood Hazard Layer
  5. U.S. EPA, Community Water System Service Area Boundaries
  6. Town of Riverhead Code § 301-230, Swimming pools
  7. Town of Riverhead Building Department

Get a written pool price in Riverhead

Tell us your town and the project. A licensed, independent Long Island pool company calls you back and gives you the price before any work starts. Free to ask, no obligation.

Get a free quote Call (631) 856-2404
  • No fee to you
  • Price in writing first
Call (631) 856-2404 Get a quote