The rules side by side
| Town of Southampton | Village of Southampton | Town of East Hampton | |
|---|---|---|---|
| Applies to pools built or rebuilt after | January 1, 2009 | July 1, 2010 | September 1, 2016 |
| Piping, over 500 sq ft (or with an auxiliary load) | at least 2 in | at least 2 in | at least 2 in |
| Piping, 500 sq ft or less | at least 1½ in | at least 1½ in | at least 1½ in |
| Elbows | — | sweep elbows only; right-angle elbows prohibited | — |
| Straight pipe before the pump | — | at least 4 pipe diameters | at least 4 pipe diameters |
| Pump type | by pool size (variable speed at 800+ sq ft) | see the village code | same sizing as Southampton |
| Controls | — | — | time switch; filtration off-peak only |
A dash means the rule wasn’t in the code section we read; ask the building department.
Southampton’s pump sizing
| Pool surface area | Required pump |
|---|---|
| Under 500 sq ft | single- or two-speed, 1 hp or less, or variable speed (two-speed or variable with an auxiliary load) |
| 500 to 799 sq ft | multispeed |
| 800 sq ft or more | variable speed |
A 16×32 rectangle is 512 square feet, so it needs at least a multispeed pump in the Town of Southampton; a 20×40 (800 square feet) needs variable speed.
Other East End equipment rules
- Town of Southampton: equipment at least 10 feet from all property lines (8 in R-10), screened, with noise mitigation; filter sizing set by type; solar heater permit fee waived.
- Town of East Hampton: pumps enclosed on all four sides for noise.
- Village of East Hampton: pool equipment fully enclosed.
More: East End pools · Town of Southampton pool rules · Town of East Hampton pool rules.
Need it done? Call for pool renovation & remodeling on Long Island. Local guides: pools in Southampton, pools in Riverhead.
Frequently asked questions
What pump does the Town of Southampton require for a pool?
By surface area: under 500 square feet, a single- or two-speed pump of 1 horsepower or less, or a variable-speed pump (two-speed or variable if there's an auxiliary load); 500 to 799 square feet, a multispeed pump; 800 square feet or more, a variable-speed pump.
When can I run my pool filter in East Hampton?
For pools built or rebuilt since September 1, 2016, the Town of East Hampton requires a time switch and says regular filtration may run only during off-peak electric demand periods (except when circulating through a heat exchanger or solar heater).
Do these rules apply to existing pools?
They apply to pools constructed or reconstructed after each code's date, and to pumps installed after it. A renovation that rebuilds the pool or replaces the pump can bring it under the rules.