Town of Southampton Building & Zoning Division
Town Hall, 116 Hampton Road, Southampton, NY 11968
Phone: (631) 287-5700
Official page
Where this code applies
Unincorporated hamlets such as Hampton Bays, Westhampton, Water Mill, Bridgehampton, Southampton (outside the village), East Quogue, Eastport, Remsenburg and Speonk. The villages of Southampton, Westhampton Beach, Quogue, Sagaponack and Sag Harbor (part) issue their own permits.
Villages inside the Town of Southampton with their own pool rules on this site: Village of Southampton (pool plumbing must use sweep elbows (right-angle elbows are banned) to save pump…). They're summarized on the pool permits hub.
What the Town of Southampton pool code requires
Permit and plans
- The building permit fee is waived for replacing or installing a pool heater when it's a solar heater.
Where the pool can go
- Pools follow the accessory-structure setbacks for your zoning district.
- Pool equipment, generators and electrical equipment must be at least 10 feet from all property lines (8 feet if the lot is entirely in an R-10 district), screened from neighbors, with noise mitigation.
Alarms, covers, equipment and neighbors
- Pools built or rebuilt since January 1, 2009: piping at least 2 inches for pools over 500 square feet (or with an auxiliary load such as a water feature), 1½ inches otherwise.
- Pumps by pool size: under 500 square feet, a single- or two-speed pump of 1 horsepower or less, or a variable-speed pump; 500 to 799 square feet, multispeed; 800 square feet or more, variable speed.
- Filters sized at 1.0 gallon per minute per square foot for cartridge, 20 for sand and 2 for DE.
Summarized from Town Code Ch. 123 Art. VI (pool energy standards) and Ch. 330 § 330-77 (accessory placement). Checked November 2026. Codes change, so confirm with the Town of Southampton building department before work starts.
What the Southampton code means on a real job
Southampton regulates the machinery more than the pool. The pump, filter, heater and any generator sit 10 feet from every property line (8 feet on all-R-10 lots), screened and quieted, which decides where the equipment pad can go on the quarter-acre lots of Hampton Bays. Pump type, pipe size and filter sizing scale with the pool's surface area for pools built or rebuilt since 2009.
That makes equipment placement a design decision. A long run from a distant pad, common on big Westhampton lots, needs the larger pipe and fewer elbows to keep pump energy down. One incentive: the building permit fee is waived when the heater you're adding or replacing is solar. See East End pool energy rules and pool heaters and heat pumps.
Ground conditions in the Town of Southampton towns on this site
| Place | Main soil | 8%+ slopes | Water table within ~3 ft | FEMA flood zone | Water supplier |
|---|---|---|---|---|---|
| Hampton Bays | Carver and Plymouth soils (3–15% slopes) | 11% | 6% | 11% | Hampton Bays Water District |
| Westhampton | Carver and Plymouth soils (0–3% slopes) | 1% | 2% | 9% | Suffolk County Water Authority |
Compare: fence rules by town · every Suffolk County office
Guides that apply here
Town of Southampton pool permit questions
Do I need a permit for a pool in the Town of Southampton?
Yes. The building permit fee is waived for replacing or installing a pool heater when it's a solar heater.
How close to the property line can a pool be in the Town of Southampton?
Pools follow the accessory-structure setbacks for your zoning district.
How high does a pool fence have to be in the Town of Southampton?
A barrier that meets the state code (at least 4 feet).
What else does the Town of Southampton code require for a pool?
Pools built or rebuilt since January 1, 2009: piping at least 2 inches for pools over 500 square feet (or with an auxiliary load such as a water feature), 1½ inches otherwise. Pumps by pool size: under 500 square feet, a single- or two-speed pump of 1 horsepower or less, or a variable-speed pump; 500 to 799 square feet, multispeed; 800 square feet or more, variable speed.