Suffolk County · Town of Islip

Pool installation in Sayville, NY: Islip setbacks and pool costs

Sayville site check: homes, soil, flood zones and water

Sayville (Census-designated place) vs. Suffolk County. Housing: Census ACS 2020–2024 5-year. Land shares: our grid sample of USDA, FEMA and EPA maps over the town boundary, November 2026.
SayvilleHereSuffolk County
Single-family detached homesabout 75%about 80%
Owner-occupiedabout 77%about 82%
Median home valueabout $637,000about $578,000
Built before 1960about 36%about 31%
Homes per square mile1,126–
Most common soilRiverhead and Haven soils, graded (0–8% slopes): regraded loam over sand and gravel (52% of land)
Land on 8%+ slopes0%
Soil with a seasonal water table within ~3 ft6%
Land in a FEMA flood zone6% (AE 5%, VE 1%, A 1%)
Public water supplierSuffolk County Water Authority (100%)
Pool permits fromTown of Islip Building Division (Department of Planning & Development), (631) 224-5466

Sayville’s older core

Sayville has more early housing than most South Shore hamlets: about 19% of homes predate 1940 and about 36% predate 1960, with a median build year of 1966 (Census ACS 2020–2024). About 75% are single-family detached, about 77% owner-occupied, and the median value is around $637,000. At about 1,126 homes per square mile, there’s roughly 24,800 square feet per home spread evenly.

Why the zoning district matters on a Sayville lot

Islip ties the pool setback to the zoning district (10 to 25 feet, measured from the pool’s outer edge, plus 6 feet for equipment), so two Sayville lots of the same size can fit different pools. In Sayville’s older core, many lots are in districts with smaller setbacks but narrower yards; in the newer sections, lots are wider but districts can be stricter. Pull your district from the survey or the town’s zoning map before choosing a size. The full table is on the Town of Islip pool permit page.

The fence and the paperwork

The barrier is 4 to 6 feet high and at least 4 feet from the pool’s edge, so the fence line eats into the yard as well. Stockade rails face in, ladders and diving boards stay inside, and no water goes in until the barrier is up. When the work is done, the homeowner receives a Certificate of Compliance.

Published Long Island prices: vinyl $35,000 – $100,000, fiberglass $45,000 – $120,000.

Flat ground, bay-side flood zones

Sayville is flat (no sample point on a slope of 8% or more) and mostly well drained: about 73% of the hamlet’s land is graded Riverhead and Haven soils or Riverhead sandy loam in the USDA soil survey, with about 10% loose Plymouth sand and 8% cut and fill. A seasonal water table within about 3 feet shows up on about 6% of the land, near the bay.

About 6% of the hamlet is in a FEMA flood zone in our sample (mostly AE, with a little VE and A), along the Great South Bay shoreline and the creeks, with base flood elevations of 5 to 7 feet. North of Montauk Highway it’s a routine dig; near the water, budget for groundwater control and keep the equipment above the flood elevation. Water comes from the Suffolk County Water Authority across the hamlet.

Old pools in an old hamlet

About 19% of Sayville homes predate 1940 (Census ACS 2020–2024), and many came with a pool added decades ago. Before replacing one, compare resurfacing or a new liner with a full rebuild, since a new pool must meet today’s district setbacks.

Soils mapped in Sayville (USDA soil survey). Look up your own lot · FEMA flood map for Sayville.
SoilShare of landWhat it isSeasonal water table
Riverhead and Haven soils, graded (0–8% slopes)52%regraded loam over sand and graveldeeper or not rated
Riverhead sandy loam (0–3% slopes)21%deep, well-drained sandy loam over sand and graveldeeper or not rated
Plymouth loamy coarse sand (0–3% slopes)10%loose, excessively drained coarse sanddeeper or not rated
Cut and fill land, gently sloping8%regraded or filled ground; ask for a soil checkdeeper or not rated

Sayville pool questions

How do I find my zoning district in Sayville?

Ask the Town of Islip's Department of Planning & Development or check the town's zoning map. The district sets your pool setback: 10 feet in most districts, 14 in Residence A, 18 in AA and AAA, and 25 in BAA.

Does the contractor need to show the permit in Sayville?

Yes. Islip requires any pool installer to have a copy of the permit before starting and to display it on site during the work. Violations carry fines of up to $5,000 per day.

How far from the pool does the fence go in Sayville?

At least 4 feet from the pool's outermost edge, between 4 and 6 feet high, under the Town of Islip code. A temporary barrier goes up during construction and the permanent one is due within 90 days.

How much of Sayville is in a flood zone?

About 6% of the hamlet's land in our sample of FEMA's current maps, mostly AE with base flood elevations of 5 to 7 feet, along the bay and creeks.

Sources

  1. U.S. Census Bureau, ACS 2020–2024 5-year: Sayville and Suffolk County housing tables
  2. USDA NRCS, Soil Survey Geographic Database (SSURGO) via Soil Data Access
  3. USDA NRCS Web Soil Survey (look up your own lot)
  4. FEMA Flood Map Service Center, National Flood Hazard Layer
  5. U.S. EPA, Community Water System Service Area Boundaries
  6. Town of Islip Code Art. XXVIII, Swimming Pools (eCode360)
  7. Town of Islip Building Division

Get a written pool price in Sayville

Tell us your town and the project. A licensed, independent Long Island pool company calls you back and gives you the price before any work starts. Free to ask, no obligation.

Get a free quote Call (631) 856-2404
  • No fee to you
  • Price in writing first
Call (631) 856-2404 Get a quote