Suffolk County · pool rules

Town of Islip pool permit: setbacks, fence rules and what to file

Town of Islip Building Division (Department of Planning & Development)
One Manitton Court, Islip, NY 11751
Phone: (631) 224-5466
Official page

Where this code applies

Unincorporated hamlets such as Bay Shore, West Islip, East Islip, Islip, Sayville, Bayport, Holbrook (part), Ronkonkoma (part), Central Islip and Brentwood. Villages such as Brightwaters, Islandia and Ocean Beach issue their own permits.

What the Town of Islip pool code requires

Permit and plans

  • A permit from the Building Division is required to build, install or keep a pool.
  • Any contractor installing a pool must first get a copy of the permit, and it must be displayed on site while work is under way. Violations carry fines up to $5,000 and up to 15 days in jail, with each day a separate violation.
  • When the pool is done, the homeowner gets a Certificate of Compliance.

Where the pool can go

  • Minimum side and rear setbacks: 18 feet in Residence AAA and AA districts, 14 feet in Residence A, 25 feet in Residence BAA, and 10 feet in all other districts. These are measured from the outside edge of an inground pool.
  • Pool mechanical equipment: at least 6 feet from side and rear lines.

Fence and barrier

  • Pools deeper than 18 inches or larger than 100 square feet need a permanent wall, fence or barrier at least 4 feet from the pool's outermost edge, between 4 and 6 feet high.
  • Stockade fences go up with the horizontal rails facing in. No projections a child could climb.
  • A temporary barrier is required during construction, and the permanent one is due within 90 days of the permit or the start of work.
  • Gates and doors self-close, self-latch, and stay locked when the pool is unattended. Ladders and diving boards must be inside the enclosure. No water goes in the pool until the barrier is up.

Alarms, covers, equipment and neighbors

  • Electrical devices must be UL-approved, with ground-fault protection.

Removing or abandoning a pool

  • An abandoned pool must be filled, the grade restored, and the Building Inspector notified, with any required Building Division permits.

Summarized from Town Code Ch. 68, Art. XXVIII (Swimming Pools), § 68-386 ff., amended through April 8, 2025. Checked November 2026. Codes change, so confirm with the Town of Islip building department before work starts.

What the Islip code means on a real job

Islip is the code where the zoning district changes the pool. The side and rear setback runs from 10 feet to 25 feet depending on the district, so two identical lots in Sayville can fit different pools. The fence adds another ring: it has to sit at least 4 feet from the pool's outer edge, which eats into small yards.

The town also requires a permit to keep a pool, not just to build one, and contractors must carry a copy of the permit and post it on site. A permanent barrier is due within 90 days of the permit. For the old pools common in East Islip, remember that a replacement has to meet today's setbacks, which may not match where the old pool sat.

Ground conditions in the Town of Islip towns on this site

Same code, different ground: shares of each place's land from USDA soil, FEMA flood and EPA water-system maps (November 2026).
PlaceMain soil8%+ slopesWater table within ~3 ftFEMA flood zoneWater supplier
Bay Shore Riverhead and Haven soils, graded (0–8% slopes) 0% 2% 8% Suffolk County Water Authority
Sayville Riverhead and Haven soils, graded (0–8% slopes) 0% 6% 6% Suffolk County Water Authority
East Islip Riverhead and Haven soils, graded (0–8% slopes) 0% 9% 8% Suffolk County Water Authority
West Islip Riverhead and Haven soils, graded (0–8% slopes) 0% 4% 7% Suffolk County Water Authority

Compare: fence rules by town · every Suffolk County office

Guides that apply here

Town of Islip pool permit questions

Do I need a permit for a pool in the Town of Islip?

Yes. A permit from the Building Division is required to build, install or keep a pool.

How close to the property line can a pool be in the Town of Islip?

Minimum side and rear setbacks: 18 feet in Residence AAA and AA districts, 14 feet in Residence A, 25 feet in Residence BAA, and 10 feet in all other districts. These are measured from the outside edge of an inground pool.

How high does a pool fence have to be in the Town of Islip?

Pools deeper than 18 inches or larger than 100 square feet need a permanent wall, fence or barrier at least 4 feet from the pool's outermost edge, between 4 and 6 feet high.

What does the Town of Islip require when you remove a pool?

An abandoned pool must be filled, the grade restored, and the Building Inspector notified, with any required Building Division permits.

What else does the Town of Islip code require for a pool?

Electrical devices must be UL-approved, with ground-fault protection.

Sources

  1. Town of Islip Code Art. XXVIII, Swimming Pools (eCode360)
  2. Town of Islip Building Division
  3. NYS Department of State: notice of adoption of the 2025 Uniform Code
  4. NYS Department of State: 2025 Uniform Code adoption (PDF)

Get a written price for your pool project

Tell us your town and the project. A licensed, independent Long Island pool company calls you back and gives you the price before any work starts. Free to ask, no obligation.

Get a free quote Call (631) 856-2404
  • No fee to you
  • Price in writing first
Call (631) 856-2404 Get a quote